Compatibility and maintenance note: This item is used for compatible printer ink-line maintenance. Please confirm size, connector type, fluid path, material requirement, and printer configuration before ordering. Actual performance depends on installation, ink/fluid type, machine condition, and operating environment.

Roland Ink Pump Motor for XJ740 / XJ640 / XC540 / XJ540

Replacement stepper motor for the peristaltic ink pump assembly used on Roland eco-solvent printers. It restores stable suction during cleaning and ink discharge cycles.

Highlights

• fitment-confirmed replacement for the ink pump drive motor (peristaltic pump).
• Stable torque and smooth rotation for application-dependent priming and capping cleans.
• Pre-wired with factory connector – plug-and-play on supported models.
• Built for solvent environments; low heat and low noise.

Compatibility

• Roland XJ-740
• Roland XJ-640
• Roland XC-540 / XC-540i
• Roland XJ-540

What’s included

• 1 × Ink Pump Stepper Motor (motor only, pump head/hoses not included)

Basic specs

Installation notes

• Power off and unplug the printer before servicing.
• Mark the motor wires and hose positions on the pump before removal.
• After installation, run a pump test/cleaning cycle to confirm proper rotation and suction.
• If the pump head is worn or hardened, replace it together with the motor for best results.

Quick troubleshooting

• Weak suction / failed cleaning: Check pump head tubing, clamps, and capping airtightness in addition to the motor.
• Motor not spinning: Verify connector seating and cable condition; check the mainboard/pump driver fuse.

Typical Failure Symptoms

• Weak suction during cleaning cycles, unstable priming, or slow waste-ink discharge from the maintenance station.
• Unusual pump noise, inconsistent cleaning results, or repeated nozzle dropouts after normal maintenance.
• Ink residue around tubes or a maintenance station that no longer pulls ink smoothly during service cycles.

Fitment Checklist

• Referenced machine models: XJ740, XJ640, XC540, XJ540, XJ-740, XJ-640, XC-540, XC-540I, XJ-540.
• Match voltage, connector style, tube count, tube direction, bracket position, and overall body dimensions with the reference pump.
• If your printer has multiple pump revisions, compare the old part directly and confirm the manufacturer reference before purchase.

Service Pairing Suggestions

• Buyers often inspect cap tops, waste tubes, dampers, and wipers at the same time when replacing a pump.
• If the machine has been standing idle for a long time, check whether the tubing and capping station also need service.
• Use this part in a solvent workflow only when the fluid path and sealing arrangement match the reference system.